P200T Manually install the driver instructions

When installing the P200T data card does not automatically install the driver, or after the installation management software prompts "please plug in the modem", then the hardware driver is not installed successfully, please manually install the hardware driver, as follows:

1, the CD-ROM copy of a copy to the local disk, or visit our website www.polar-rig.com into the download center, download "P200T hardware driver." 

2, as shown below Right-click Ewlker-popular, and then click "pop-up"

3, as shown below Select "from the list or designated location", click "Next"

4, as shown below, select "include this location in the search," click "Browse" to select the destination folder "driver" where the path. Click "OK" and click "Next" to start the installation.

5, repeat steps three, four, until the completion of the installation of the four components below

6, After installation, you can check whether the installation is successful by Device Manager. If there is no successful installation, you will see a yellow exclamation point or question mark. At this time, you can right-click to update the driver to complete the installation, as shown in the following figure Complete hardware driver installation success)

7, when found that the new hardware can be used, then install the G3_eWalk folder "setup.exe" can be.